The Ohlins STX 36 scooter rear shock for the Honda Lead 125 is built to improve damping control and chassis stability in everyday riding. It is a gas-pressurised, oil/gas separated design to help maintain consistent performance as conditions change. The result is more predictable support under braking and through corners, with clearer feedback from the rear end.

Ohlins | Made to race, perfected to ride

Ohlins suspension focuses on controlled damping behaviour and repeatability. This unit is aimed at riders who want a more composed rear suspension response without sacrificing ride quality for typical scooter use.

Who this shock is for

  • Honda Lead 125 riders wanting improved stability and traction from the rear suspension
  • Commuters who ride varied road surfaces and want more consistent damping feel
  • Riders who value adjustability to suit load, speed and road conditions

Shock design & features

  • STX 36 scooter shock architecture
  • Gas-pressurised with oil/gas separation to support consistent damping
  • Rear mono-shock fitment

Tuning controls

This shock includes external adjusters for both rebound damping and compression damping, allowing you to balance comfort, grip and chassis control to suit your riding conditions.

Before you install

  • Confirm correct fitment for Honda Lead 125 and rear mono-shock configuration
  • Set sag and check spring suitability for your typical load
  • After installation, re-check fasteners and inspect clearance through full suspension travel

Serviceability/lifecycle

Like performance suspension, periodic servicing helps maintain damping consistency and seal life. Use the recommended Ohlins oil specified for this unit during service.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO328
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 328.5
Spring Rate Standard 25.0 - 45.0 N/mm Progressive
Type Code S36PR1C1
Product Family STX 36 Scooter
Fitted Spring 60001-02
Rec. Ohlins Oil 01309-

More From This Category