The Ohlins KA465 is a rear mono shock built around the TTX GP architecture for Kawasaki Z H2 fitment. It is designed to deliver consistent damping control and clear chassis feedback under hard acceleration and braking. This unit uses a separated oil/gas layout to help maintain damping stability during sustained heat and load.

Ohlins | Made to race, perfected to ride

Developed from Ohlins road racing experience, this shock focuses on predictable grip and support when riding at higher pace. The damping circuits are designed to maintain control through corner entry, mid-corner support and drive off the apex.

Who this shock is for

Suited to riders who push a Z H2 hard on road or track and want a broader, more precise tuning range than stock. It is also appropriate when you are chasing improved stability during braking and stronger traction on corner exit.

Shock design & features

This is a TTX GP rear shock with separated oil and gas for damping consistency. The internal layout is intended to reduce cavitation risk and keep response repeatable during longer sessions.

Tuning controls

The KA465 provides external adjustment for rebound damping and compression damping, along with ride height adjustment. These controls allow you to balance support, grip and geometry to suit tyres, pace and track conditions.

Before you install

  • Confirm suitability for your exact model variant; this unit is noted as not for SE version.
  • Check spring selection and compatibility with your load and riding style (fitted spring noted in the product data).
  • Plan a baseline setup after fitment so you can make changes methodically.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA465
Model # T36PR1C1LS
Barcode # KA465
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 312.0 +6/-0
Spring Rate Standard 120.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 57.0
Product Family TTX GP
Notes Not for SE version
Fitted Spring 21040-44
Rec. Ohlins Oil 01309-

More From This Category