The Ohlins STX 36 Supersport rear shock for Kawasaki KSR 110 is built for riders chasing more consistent chassis control and clearer rear-tyre feedback. It uses a pressurised, separated oil/gas design to maintain damping stability as conditions and pace change. Designed as a direct-fit rear mono shock, it provides practical adjustability for track use and spirited riding.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing architecture, this unit focuses on predictable damping behaviour and reliable traction. The STX platform is widely used where repeatable performance and tuning range matter.

Shock design & features

  • STX 36 Supersport rear mono shock configuration
  • Pressurised damping with oil/gas separation for stable performance
  • Built for consistent feel under acceleration, braking, and direction changes

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Base setup (factory preset)

Supplied with an Ohlins baseline setting intended to be a safe starting point for the KSR 110. From there, fine-tuning rebound, compression, and preload helps match rider weight, tyres, and typical road or track conditions.

Before you install

  • Confirm fitment for Kawasaki KSR 110 and rear mono mounting before installation
  • After installation, set sag and re-check fasteners after the first ride
  • If you change ride height or damping, make one change at a time and record it

Serviceability/lifecycle

This Ohlins shock is fully serviceable. Regular servicing helps maintain damping consistency and extends component life, particularly when used in wet, dusty, or high-heat conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA607
Model # S36HR1C1L
Barcode # KA607
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 235.0 +7/-3
Type Code S36HR1C1L
Stroke Metal to Metal (mm) 34.0
Product Family STX 36 Supersport
Fitted Spring 00282-05
Spring Colour Yellow

More From This Category