The Ohlins STX 36 Supersport rear shock for the Kawasaki KR 150 is built around race-derived damping control for consistent feel and repeatable setup changes. It uses a pressurised oil/gas separated design to maintain stable damping under sustained load. Separate damping circuits let you tune chassis behaviour to suit your tyres, track surface, and riding style.

Ohlins | Made to race, perfected to ride

Developed from Ohlins supersport hardware, this unit focuses on controlled support, clear feedback, and traction management. The STX 36 architecture is intended for riders who need predictable damping through braking, turn-in, and drive. It is suited to performance street use and track work where consistent behaviour matters.

Who this shock is for

  • Riders chasing improved rear-end control and feel on a KR 150.
  • Track day riders and club racers who want dependable damping consistency.
  • Owners who want a shock that supports structured setup work (springs and damping).

Shock design & features

  • Pressurised oil/gas separated damping system for consistent performance.
  • Monoshock rear fitment application.
  • STX 36 Supersport platform aimed at stable chassis support and traction control through corners.

Tuning controls

  • Rebound damping adjustment to manage how quickly the shock extends after compression.
  • Compression damping adjustment to control support under load and bump absorption.

Before you install

  • Confirm correct fitment for your exact KR 150 model and year before installation.
  • Set sag and baseline damping to suit rider weight and intended use before fine-tuning.
  • If changing springs, re-check sag and revisit damping settings to match the new balance.

Serviceability/lifecycle

Like all performance dampers, this shock is a service item. Periodic oil and seal service helps maintain damping consistency and extends component life, especially with frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA764
Model # S36HR1C1L
Barcode # KA764
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 311.0 +10/-0
Spring Rate Standard 62.0 N/mm
Type Code S36HR1C1L
Stroke Metal to Metal (mm) 64.0
Product Family STX 36 Supersport
Fitted Spring 60281-44
Rec. Ohlins Oil 01309-

More From This Category