The Ohlins STX 46 Supersport rear shock is a purpose-built upgrade for Ducati fitments where consistent damping control and track-focused feel are priorities. Built around Ohlins’ proven monotube architecture, it’s designed to deliver stable behaviour under load and clear feedback at the tyre. This unit is supplied for rear mono-shock applications.

Ohlins | Made to race, perfected to ride

STX 46 Supersport shocks are developed from Ohlins’ racing programs and refined for performance road and track use. The focus is on predictable damping characteristics, durability, and adjustability that lets you match the bike to your tyres, surfaces, and riding style.

Who this shock is for

This rear shock suits riders chasing a more controlled chassis with improved support during braking, corner entry, and drive off turns. It’s also appropriate when you want a serviceable performance shock rather than a sealed, replace-only unit.

Shock design & features

This is a gas-separated monotube design rather than an emulsion shock, helping maintain damping consistency during hard use. It uses a single main piston arrangement with a separate gas volume to reduce cavitation and keep response stable as temperatures rise.

Tuning controls

This shock includes rebound damping adjustment and compression damping adjustment, allowing you to balance traction, support and ride quality. Preload adjustment is provided to set sag correctly for your weight and intended use.

Before you install

Set sag first, then fine-tune damping with small changes and one adjustment at a time. If you are changing ride height, check chain run, tyre clearance and overall chassis balance. After installation, re-check fastener torque and confirm free movement through suspension travel.

Serviceability/lifecycle

Ohlins performance shocks are designed to be maintained with routine servicing to keep damping behaviour consistent over time. Fresh oil and seals at appropriate intervals helps preserve control, especially if the bike sees track use or sustained high temperatures.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU334P3
Model # S46PR1C2B
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 301.0
Spring Rate Standard 70.0 N/mm
Type Code S46PR1C2B
Stroke Metal to Metal (mm) 69.0
Product Family STX 46 Supersport
Fitted Spring 01092-19
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category