The Ohlins STX 46 Street rear shock for Ducati 900 SS and 1000 SS is built to improve chassis control and feedback in real-world road riding. It uses a monotube layout intended to deliver consistent damping behaviour as conditions change. This unit is supplied as a rear mono shock for the listed Ducati models.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed from competition experience and adapted for street use where compliance, stability and predictable response matter. The STX 46 Street family focuses on controlled damping with a practical adjustment range for everyday tuning.

Shock design & features

This is an oil and gas separated rear shock design to help keep damping consistent during extended use. The STX monotube architecture supports stable damping performance and clear feel at the tyre contact patch.

Tuning controls

This shock provides rebound damping adjustment and compression damping adjustment, allowing you to tailor response for comfort, grip and chassis balance. Adjustments are intended to help match riding style, road surface and loading.

Base setup (factory preset)

The shock is delivered with a factory baseline setup as a starting point for your Ducati. Fine-tuning is typically done after confirming sag and ensuring the shock is operating in the correct part of its stroke for your riding conditions.

Before you install

  • Confirm fitment for Ducati 900 SS and 1000 SS and check overall condition of mounting hardware and linkage bearings (if applicable).
  • Set sag for your weight and typical load, then use damping adjustments to refine control and comfort.
  • If you change spring rate from what is supplied, re-check sag and damping balance.

Serviceability/lifecycle

Like all performance suspension, regular servicing helps maintain damping consistency and seal life. Plan periodic inspection and service based on usage, environment and kilometres.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU010
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 336.0 +8/-4
Spring Rate Standard 70.0 - 120.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 76.0
Product Family STX 46 Street
Fitted Spring 01106-02
Spring Colour Yellow
Rec. Ohlins Oil 01309-

Related products

More From This Category