The Ohlins DU927 is a rear TTX RT shock absorber developed for the Ducati 1199 Panigale. Built around Ohlins’ twin-tube damping architecture, it is designed to deliver consistent control and clear chassis feedback during demanding road and track use. The design separates oil and gas to help maintain stable damping feel as conditions change.

Ohlins | Made to race, perfected to ride

TTX RT technology is derived from Ohlins road racing development, adapted for high-performance street and track motorcycles. The focus is predictable damping behaviour, grip management and rider confidence when pushing the chassis hard.

Who this shock is for

Suitable for riders who want a more tuneable rear suspension than standard, with a consistent feel under heavy braking, quick direction changes and strong drive on corner exit. It suits riders who value adjustability for tyre choice, pace and surface conditions.

Shock design & features

This model uses an oil/gas separated design with Ohlins twin-tube damping to promote consistent pressure control and response. The internal layout supports stable damping characteristics and repeatable behaviour across a wide range of operating conditions.

Tuning controls

Provides external adjustment for rebound damping and compression damping, allowing you to balance support and compliance to suit your setup. Spring preload adjustment is included for setting ride height and sag correctly to the motorcycle and rider load.

Before you install

  • Confirm fitment for Ducati 1199 Panigale and rear mono-shock configuration before installation.
  • This unit is supplied with an Ohlins spring fitted (01092-26).
  • After installation, set sag and baseline damping to match your tyres, riding conditions and intended use.

Serviceability/lifecycle

Like all performance shocks, routine servicing helps maintain oil condition, seal integrity and consistent damping. Plan servicing around use intensity (track work typically requires more frequent maintenance) to keep performance predictable.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU927
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0 +11-1
Spring Rate Standard 85.0 N/mm
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX RT
Fitted Spring 01092-26

More From This Category