The Ohlins BM708 STX 46 Street is a rear shock absorber for the BMW R 1200 R, built around Ohlins road-focused damping control and ride consistency. It uses a separated oil/gas design to help keep damping stable through changing conditions. This unit is intended to provide controlled chassis behaviour and clearer feedback without relying on harsh springing.

Ohlins | Made to race, perfected to ride

STX technology is developed from Ohlins experience across performance road and competition applications, then tuned for real-world street use. The aim is predictable grip, stable braking attitude and composed cornering on a wide range of surfaces.

Shock design & features

  • Rear mono-shock layout suited to the BMW R 1200 R application.
  • Oil and gas are separated to support consistent damping behaviour.
  • STX 46 Street product family architecture.

Tuning controls

  • Rebound damping adjustment to control how quickly the shock returns after compression.
  • Compression damping adjustment to manage chassis support under bumps and load transfer.
  • Spring preload adjustment to set ride height and suit rider/load conditions.

Base setup (factory preset)

This shock is supplied with an Ohlins-fitted spring and a baseline internal setting from the factory. Start by setting sag and ensuring preload is matched to your typical riding load, then fine-tune compression and rebound to suit your preferred feel and road conditions.

Before you install

  • Confirm the mounting position is rear and that the motorcycle application matches your BMW R 1200 R model/fitment requirements.
  • After installation, re-check clearances and set preload and damping with the bike at operating load.
  • Use the recommended Ohlins suspension oil when servicing.

Serviceability/lifecycle

Ohlins shocks are designed to be serviceable so performance can be maintained over time. Periodic inspection and servicing helps keep damping consistent and protects internal components as the oil ages and seals wear.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM708
Model # S46PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 380.0 +12/-0
Spring Rate Standard 190.0 N/mm
Type Code S46PR1C1LS
Stroke Metal to Metal (mm) 54.0
Product Family STX 46 Street
Notes Rear
Fitted Spring 01092-79
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category