The Ohlins DU015 STX 46 Adventure rear shock is built to improve control and consistency for Ducati ST 4 riders in adventure and touring use. It is designed to maintain stability over rough surfaces and when the bike is loaded for longer days. This is an oil/gas separated shock design for more consistent damping under demanding conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered with a focus on damping control, ride support and repeatable performance across changing conditions. The STX Adventure platform is aimed at mixed-surface riding where comfort and composure matter as much as feedback.

Who this shock is for

  • Ducati ST 4 owners using the bike for touring and mixed-surface riding
  • Riders carrying luggage or a passenger who want more stable rear support
  • Anyone chasing clearer traction feel and reduced wallow over uneven roads

Shock design & features

This rear mono shock uses a separated oil/gas layout to help keep damping stable during long, rough rides. It is part of the Ohlins STX 46 Adventure family and is intended to deliver controlled movement and predictable support through a wide range of conditions.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to tune feel and chassis balance to your load and riding conditions. Spring preload adjustment lets you set ride height and support for solo riding, luggage, or a pillion.

Before you install

  • Confirm fitment for Ducati ST 4 and check clearance around exhaust, linkages and bodywork.
  • Set sag and preload for your typical load, then fine-tune rebound and compression to match road and surface conditions.
  • Inspect bearings/bushes and linkage condition during installation to ensure the suspension can move freely.

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be serviced to maintain performance over time. Regular inspection and servicing helps keep damping consistent, particularly if the bike sees heavy loads or frequent rough-road use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU015
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0
Spring Rate Standard 95.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 63.0
Product Family STX 46 Adventure
Fitted Spring 01092-31

More From This Category