The Ohlins DMX0217 TTX Flow DV rear shock is built for MX and enduro applications where consistent damping control and clear feedback matter. Designed as a rear mono shock for the Stark VARG, it supports precise setup changes to suit rider preference and track conditions. This unit uses a separated oil/gas design to help maintain damping consistency during demanding riding.

Ohlins | Made to race, perfected to ride

TTX Flow DV technology draws on Ohlins race development to deliver stable, predictable shock behaviour through a wide range of operating conditions. The focus is on controlled chassis movement and repeatable feel rather than a “one setting fits all” tune.

Shock design & features

  • Rear mono shock configuration for Stark VARG fitment
  • Separated oil/gas architecture for consistent damping performance
  • TTX Flow DV product family design intent aimed at control and traction

Tuning controls

This rear shock provides external damping adjustment for both compression and rebound, allowing you to balance support, traction and stability to match conditions and riding style.

Before you install

  • Spring is sold separately; confirm the correct spring rate for your weight and use
  • Check fitment and model compatibility for the Stark VARG prior to installation
  • Note: this part is listed as replaced by DMX 1217

Serviceability/lifecycle

As with all performance suspension, routine servicing helps keep damping consistent and internal wear controlled. Use the recommended Ohlins oil specified for the unit during service.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0217
Model # T46PR1C2W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 470.0
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 135.0
Product Family TTX Flow DV
Notes *Replaced by DMX 1217*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category