The Ohlins DMX1215 TTX Flow DV rear shock is built for the KTM 450 SX-F as a rear mono shock replacement. It uses a gas-pressurised damping system intended to keep damping behaviour consistent through demanding riding. Independent compression and rebound circuits are provided to help tailor feel to track conditions and rider preference.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing technology, this unit is aimed at delivering clear feedback and chassis control when riding aggressively. The TTX Flow DV platform is designed around stability, traction and predictable behaviour under load.

Who this shock is for

Suited to KTM 450 SX-F riders who want a more tunable rear end and improved control for motocross or hard-paced riding. It is also a fit if you are replacing an existing Ohlins unit noted as DMX 0215.

Shock design & features

This is an oil/gas separated, gas-pressurised rear mono shock. The damping layout uses separate circuits for compression and rebound to support consistent control and traction, including when braking hard and driving out of corners.

Tuning controls

Adjustments are provided for compression damping and rebound damping, allowing you to fine-tune response for different track surfaces and rider feel. Spring preload is set via the shock’s preload arrangement; a compatible preload adjuster is listed in the product notes.

Before you install

  • Spring is sold separately; refer to the notes regarding the 06310- series spring requirement.
  • Preload adjuster 15000-02 is noted as compatible with this shock.
  • Use the recommended Ohlins oil as specified: 01304-.

Serviceability/lifecycle

As an Ohlins performance shock, periodic servicing is part of normal ownership to keep damping consistent and internal wear controlled. Maintain clean external condition and address oil leaks or changes in feel promptly.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX1215
Model # T46PR1C2W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 457.0
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 137.0
Product Family TTX Flow DV
Notes 06310- series spring. Preload adjuster 15000-02 fits this shock. *Replaces DMX 0215*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category