The Ohlins TTX Flow rear shock for Honda CRF 450R is built around a twin-tube damping layout aimed at delivering stable control and consistent feel across changing track conditions. It is supplied without a spring, allowing you to match spring choice to rider weight and use. This unit is intended as a direct-fit rear mono shock replacement for motocross and enduro applications.

Ohlins | Made to race, perfected to ride

TTX Flow technology is designed to keep damping performance consistent under demanding off-road use. The twin-tube architecture supports controlled oil flow through the damping circuits for predictable response and chassis feedback.

Shock design & features

  • Rear mono shock configuration to suit Honda CRF 450R fitment
  • Ohlins TTX Flow twin-tube damping design
  • Supplied with no spring fitted (spring sold separately)

Tuning controls

This shock includes external damping adjustments for both compression and rebound, allowing you to tune the balance of support and traction to suit conditions and riding style.

Before you install

No spring is supplied with this unit. It is intended to be used with a 06310-series spring; select the correct rate and fitment before installation.

Serviceability/lifecycle

Like all performance off-road shocks, routine servicing helps maintain damping consistency and seal life. Service intervals should be set based on hours and operating conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO1894
Model # T46PR1C1W
Barcode # HO1894
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

Related products

More From This Category