The Ohlins TTX Flow rear shock for Yamaha WR 450F is built around a race-derived damping architecture aimed at maintaining consistent control across changing track and trail conditions. It uses a separated oil and gas design to help keep damping stable during sustained hard use. The layout supports focused tuning of the chassis balance without resorting to guesswork.

Ohlins | Made to race, perfected to ride

TTX Flow is Ohlins’ twin-tube concept applied to off-road rear suspension, developed with an emphasis on predictable damping and traction. The design targets repeatable behaviour through the stroke and improved sensitivity over varied terrain.

Who this shock is for

  • WR 450F riders wanting higher damping consistency under aggressive riding
  • Enduro and motocross riders who tune suspension for conditions and pace
  • Owners upgrading for improved control and rear-wheel traction

Shock design & features

  • Rear mono shock configuration
  • Separated oil and gas design to support stable damping behaviour
  • TTX Flow twin-tube damping architecture for controlled oil flow and response

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • No spring supplied; spring is sold separately
  • Check spring compatibility and selection notes before ordering

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA1794
Model # T46PR1C1W
Barcode # YA1794
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 458.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Stroke Metal to Metal (mm) 121.0
Product Family TTX Flow
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

More From This Category