The Ohlins DU361 TTX GP rear shock is built around race-proven damping architecture for riders chasing accurate chassis control on Ducati 899 and 959 Panigale models. It delivers consistent damping behaviour under hard braking, rapid direction changes and high load corner exits. The design focuses on clear feedback and repeatable performance when pace increases.

Ohlins | Made to race, perfected to ride

From the TTX GP family, this unit is aimed at riders who want a high-level rear suspension package with a wide tuning window. It is suited to track use and fast road riding where stability and traction matter most.

Who this shock is for

  • Ducati 899/959 Panigale owners upgrading the rear mono for more precise damping control
  • Track-focused riders needing consistent behaviour session to session
  • Road riders who value stability and rear grip during aggressive riding

Shock design & features

  • TTX GP architecture with oil and gas separation for consistent damping
  • Gas-pressurised design to help maintain damping stability during sustained heat and load
  • Independent compression and rebound damping circuits to support detailed tuning

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Hydraulic preload adjustment
  • Length adjustment

Before you install

  • Rear mono fitment for Ducati 899 Panigale and 959 Panigale as listed
  • Note: this part number is marked as replaced by DU 469
  • Supplied with Ohlins spring 01092-24 (yellow)

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU361
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 312.0 +4/-8
Spring Rate Standard 80.0 N/mm
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX GP
Notes **Replaced by DU 469**
Fitted Spring 01092-24
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category