The Ohlins STX 46 Street rear shock for the Ducati Paul Smart is built to improve chassis control and tyre contact across real-world road riding. Its damping layout is derived from Ohlins race development, with a focus on predictable feedback and stability. Gas pressurisation helps maintain consistent damping behaviour as conditions change.

Ohlins | Made to race, perfected to ride

STX 46 Street units are engineered for riders who want a disciplined, controlled feel rather than an overly firm ride. On the Paul Smart, this style of rear shock targets improved traction and composure through corners and under braking.

Shock design & features

  • STX 46 Street rear mono shock configuration
  • Oil and gas are separated to support consistent damping and reduce fade during harder use
  • Race-developed internal architecture focused on clear feedback and stability

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Length adjustment to fine-tune rear ride height and chassis balance
  • Spring preload adjustment (via the fitted spring)

Base setup (factory preset)

This shock is supplied with an Ohlins spring fitted (00698-90) and is intended to be installed and ridden with the factory baseline as a starting point. From there, small changes to compression and rebound can be used to match road surface, load, and rider preference.

Before you install

  • Confirm fitment for Ducati Paul Smart and check clearance at full suspension travel
  • Set sag and preload before making damping changes
  • After installation, re-check fasteners and linkage condition as part of your setup process

Serviceability/lifecycle

As an Ohlins rear shock, the DU246 is designed to be serviced to maintain performance over time. Regular inspection and periodic servicing will keep damping consistent and help protect internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU246
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 380.0 +6/-6
Spring Rate Standard 32.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 94.5
Product Family STX 46 Street
Fitted Spring 00698-90
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category