The Ohlins DU968 TTX RT rear shock absorber is built for Ducati Multistrada 1200 Pikes Peak and Multistrada 1200S riders chasing consistent chassis control and clear feedback. Based on Ohlins TTX RT architecture, it uses separated oil and gas to help maintain stable damping over long, demanding rides. Independent adjusters let you tailor the feel for load, road conditions and riding style.

Ohlins | Made to race, perfected to ride

TTX RT technology brings race-developed damping behaviour to a road-focused rear mono shock package. The design is aimed at predictable response under braking, corner entry and acceleration.

Who this shock is for

  • Multistrada riders who want more control and traction from the rear end
  • Owners who tune suspension to suit different roads, pace and luggage/passenger use
  • Riders looking for consistent damping feel over longer, harder sessions

Shock design & features

  • TTX RT rear mono shock design
  • Oil and gas are separated to support stable damping behaviour
  • Developed from Ohlins race-proven damping concepts for accurate wheel control

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm fitment for Ducati Multistrada 1200 Pikes Peak and Multistrada 1200S
  • Plan to set sag and then fine-tune compression and rebound to match your load and riding conditions

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU968
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 70.0
Product Family TTX RT

More From This Category