The Ohlins DU955 TTX RT rear shock is built around track-developed damping control for the Ducati Panigale R. It is designed to deliver clear feedback and stable chassis behaviour when riding at higher loads. As a rear mono shock, it focuses on consistent control through the stroke and predictable response to setup changes.

Ohlins | Made to race, perfected to ride

Ohlins TTX RT technology is based on the brand’s racing suspension experience, adapted for high-performance road and track use. The design emphasises damping precision and repeatability so adjustments translate cleanly to on-bike feel.

Who this shock is for

Suited to Panigale R riders who want a dedicated performance rear shock with broad tuning capability. It’s a strong match for regular track work, or for riders chasing more consistent rear grip and stability under hard acceleration and braking.

Shock design & features

This is a gas-pressurised rear shock with separated oil and gas to help maintain damping consistency as temperatures rise. It uses the Ohlins TTX RT layout to support stable damping behaviour and improved traction feel across changing conditions.

Tuning controls

The DU955 provides independent compression and rebound damping adjustment, allowing you to balance support and grip to suit tyres, pace and surface. It also includes spring preload adjustment for setting ride height and sag correctly.

Before you install

Confirm fitment for Ducati Panigale R and check that your linkage and bearings are in good condition before installation. After fitting, set sag first, then fine-tune damping to match your tyres and typical operating temperatures.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU955
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX RT

More From This Category