The Ohlins DU930 TTX RT rear shock is built for Ducati 1199 Panigale fitment where consistent damping control and clear feedback matter. Developed from Ohlins TTX architecture, it separates damping circuits to maintain stability during aggressive riding. This unit is designed as a rear mono shock with serviceable construction for ongoing performance.

Ohlins | Made to race, perfected to ride

TTX RT technology is derived from Ohlins road and race development, focusing on predictable chassis behaviour and repeatable damping. The design aims to deliver controlled support through braking, cornering and acceleration without relying on vague “one setting fits all” behaviour.

Shock design & features

  • TTX twin-tube damping architecture with oil and gas separation for consistent performance
  • Rear mono shock configuration for Ducati 1199 Panigale applications
  • Designed around stable damping control under changing loads and temperatures

Tuning controls

  • Spring preload adjustment
  • Rebound damping adjustment
  • Compression damping adjustment

Is it right for you?

This shock suits riders who want broader tuning range and more defined damping response than a basic replacement unit. If you ride spirited road kilometres or track days and prefer the ability to adjust both compression and rebound to match tyres, pace and conditions, this configuration is a strong fit.

Serviceability/lifecycle

Ohlins units are intended to be maintained. Regular servicing helps keep damping performance consistent and extends component life, especially when the bike sees hard road use or track work.

Before you install

Confirm the bike model and year compatibility and check clearance around the reservoir and adjusters. Set sag and baseline clicker positions after installation to suit rider weight and intended use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU930
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 312.0 +4-8
Spring Rate Standard 90.0 N/mm
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX RT
Notes *Replaced by DU 340* Type T36PR1C1L
Fitted Spring 01092-29

More From This Category