The Ohlins STX 46 Street rear shock for Ducati Hypermotard 1100 EVO SP is built to deliver clear feedback and controlled damping for real-world road riding. It’s a mono shock designed to improve stability and traction when the pace picks up, while retaining ride quality over imperfect surfaces. This unit uses a separated oil/gas layout to help maintain consistent damping during longer, harder rides.

Ohlins | Made to race, perfected to ride

Ohlins road shocks are developed from the same damping principles used in competition, then refined for predictable behaviour on the street. The focus is on stability, support and feel at the tyre contact patch, so the bike remains composed through braking, turn-in and drive.

Shock design & features

  • STX 46 Street mono shock architecture for rear fitment
  • Separated oil/gas design to help reduce damping fade during extended use
  • Valving aimed at controlled chassis movement and improved traction feel

Tuning controls

  • Rebound damping adjustment to fine-tune return speed and grip on corner exit
  • Compression damping adjustment to tune support under braking and load changes

Base setup (factory preset)

This shock is supplied with an Ohlins baseline setting intended as a practical starting point for road use. Final adjustment should be made to suit rider weight, tyres, road conditions and preferred balance.

Before you install

Confirm model compatibility and check linkage, bearings and mounting hardware condition before fitting. After installation, set sag and then adjust rebound and compression in small steps so changes can be felt and verified safely.

Serviceability/lifecycle

Ohlins units are serviceable and intended to be maintained to keep damping consistent over time. Regular inspection for leaks and bushing wear, along with periodic oil and seal service, will help preserve performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU746
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 300.0
Spring Rate Standard 80.0 N/mm
Type Code S46PR1C1
Stroke Metal to Metal (mm) 70.5
Product Family STX 46 Street
Fitted Spring 01096-24
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category