The Ohlins DU112 rear mono shock is built around Ohlins STX 46 Street architecture for the Ducati Supersport S. It is designed to deliver controlled damping with a consistent feel across a wide range of road conditions. This unit uses a gas-pressurised, oil/gas separated design to help maintain damping stability as temperatures change.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how and tuned for street use, this shock focuses on predictable chassis behaviour and tyre contact. It is intended to support confident cornering and stable braking without making the ride harsh.

Who this shock is for

  • Riders upgrading the standard rear suspension on a Ducati Supersport S for improved control and consistency
  • Owners who want external damping adjustment to suit different roads, tyres and riding styles
  • Street and spirited weekend riders looking for a more settled rear end under acceleration and braking

Shock design & features

This is an STX 46 Street rear mono shock with a gas-pressurised layout and oil/gas separation for consistent damping. The internal damping circuits are designed to provide stable support while maintaining compliance over typical street surfaces.

Tuning controls

You can adjust rebound damping, compression damping and spring preload. These controls allow you to fine-tune how the rear returns after bumps, how it resists compression loads, and how the bike sits in its stroke for balance and traction.

Before you install

  • Confirm the application and fitment for Ducati Supersport S and rear mono position before installation
  • Set sag and preload first, then refine rebound and compression to suit your load and riding conditions
  • If you are changing ride height through setup, check chain slack and clearances through full suspension travel

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain damping quality and seal life. A scheduled service refreshes oil and wear components to keep the shock performing as intended over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU112
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code S46PR1C1
Stroke Metal to Metal (mm) 62.0
Product Family STX 46 Street
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category