The Ohlins FCX1201 TTX 22 fork cartridge kit is designed to sharpen front-end feel and maintain braking stability across a wide range of KTM off-road models. Built around Ohlins’ TTX 22 cartridge concept, it focuses on consistent damping behaviour and clearer feedback at the bars. It suits riders looking for more control and confidence from their standard fork setup.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, this cartridge kit targets improved composure and communication from the front end. The aim is predictable response through braking zones and into turns.

Who this fork cartridge is for

  • Riders chasing improved front-end feedback and stability under braking
  • KTM motocross and off-road riders who want a more controllable fork feel
  • Anyone wanting more confidence and composure from the front tyre in corners

Shock design & features

  • TTX 22 fork cartridge kit construction
  • Premium internal components intended for consistent, reliable damping
  • Designed to improve mid-corner feel and front-end composure

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Is it right for you?

If you value clear front-end feedback and want the ability to fine-tune damping for your terrain and pace, the FCX1201 is a logical choice. It’s intended to deliver a more communicative ride without making the fork feel unpredictable when pushing or braking hard.

Before you install

Confirm fitment for your exact KTM model and year before installation. For best results, have the kit installed and set up by a qualified suspension technician.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FCX1201
Model # T22DR1C1
Barcode # FCX1201
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code T22DR1C1
Fork Length (mm) 940.0
Stroke Metal to Metal (mm) 302.0
Product Family TTX 22
Notes 08765- series springs *Replaces FCX 201*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01330-

More From This Category