The Ohlins FCX0203 TTX 22 fork cartridge front is designed to improve front-end control and feel on Yamaha YZ 250F and YZ 450F models. It focuses on delivering consistent damping and clearer feedback through the bars for more confident riding. Adjustment is straightforward, allowing you to tailor the fork response to your needs.

Ohlins | Made to race, perfected to ride

  • Ohlins TTX 22 fork cartridge system
  • Built for improved control and rider feedback

Who this cartridge kit is for

  • Riders chasing improved braking stability and a more composed front end
  • Yamaha YZ 250F and YZ 450F owners looking for more precise fork behaviour

Shock design & features

  • Refined damping system aimed at consistent performance
  • Premium internal components for durability under demanding use

Tuning controls

  • Separate compression and rebound adjustment
  • Designed to make setup changes clear and repeatable

Before you install

  • Follow Ohlins fitting instructions and spring recommendations for correct setup
  • Confirm application suitability for your exact Yamaha model and year before installation

***** SEE RESOURCES TAB FOR FITTING DETAILS *******

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FCX0203
Model # T22DR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Type Code T22DR1C1
Fork Length (mm) 953.0
Stroke Metal to Metal (mm) 301.0
Product Family TTX 22
Notes 08765- spring series *Replaces FCX 203-21*
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01330-

We Also Recommend

Related products

KLE 500 Fork Kit 9 In Stock

KLE 500 Fork Kit

Add some adustment to your forks(SKU: 30-162-00)

$330.00

More From This Category