The Ohlins FGK135 NIX 30 fork cartridge kit is designed to improve front-end control and feel on the Honda CBR600RR. It focuses on delivering more consistent damping and clearer feedback under braking and through corners. With external adjustability, it allows you to tailor the fork response to your riding and conditions without changing the character of the bike.

Ohlins | Made to race, perfected to ride

Ohlins cartridge kits are built around accurate damping control and repeatable adjustment. The FGK135 is intended for riders who want a more supportive and communicative front end for road and track use.

Who this kit is for

  • CBR600RR riders chasing improved braking stability and front-end feedback
  • Street riders who want a more controlled, confidence-inspiring fork feel
  • Track day riders looking for a wider tuning range and consistent response

Fork design & features

  • NIX 30 cartridge architecture for refined damping control
  • Premium internal components aimed at consistent performance and durability
  • Designed to enhance mid-corner feel and stability under load

Tuning controls

  • Separate compression and rebound adjustment to fine-tune fork behaviour
  • Adjustment range suited to both road settings and occasional track use

Before you install

  • Confirm model compatibility for your specific Honda CBR600RR variant before fitting
  • Correct installation and setup are critical to getting the best feel and stability from the kit
  • After installation, plan time to dial in settings to match your riding style and tyres

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGK135
Model # NIX 30
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate Standard 9.0 N/mm
Type Code NIX 30
Product Family NIX 30
Notes Both with and without ABS
Fitted Spring 04744-90

More From This Category