The Ohlins FGK137 NIX 30 fork cartridge kit is a front-end suspension upgrade for the Yamaha YZF R6, focused on improving control, feedback and stability under braking. Built around Ohlins cartridge internals, it delivers more consistent damping behaviour than stock components. Separate damping circuits allow more direct tuning for your riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins cartridge kits are designed to deliver clear front-tyre communication and predictable support through braking and corner entry. The FGK137 is intended to help the fork respond with greater control across changing loads and road or track surfaces.

Who this kit is for

  • YZF R6 riders wanting improved front-end feel and braking stability
  • Street riders who also do occasional track days
  • Riders who prefer adjustability to dial in their own setup

Shock design & features

  • NIX 30 cartridge design
  • Premium internal components for consistent damping performance
  • Improved composure and front-end feedback compared with standard fork internals

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Before you install

  • Designed as a cartridge kit installation into the front forks
  • Correct installation and setup are important to get the intended damping control and feel

Need help choosing?

If you’re deciding between a cartridge upgrade and other suspension changes, consider how you use the bike (street vs track), your preference for adjustability, and whether braking stability or mid-corner feedback is the main priority.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGK137
Model # NIX 30
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Front cartridge
Spring Rate Standard 9.0 N/mm
Type Code NIX 30
Product Family NIX 30
Fitted Spring 04744-90

More From This Category