The Ohlins NIX 22 fork cartridge kit is designed to upgrade the front suspension of the Yamaha R3 with more controlled damping and clearer feedback. It targets improved stability under braking and a more composed feel through corners. Adjustment is built in so you can tune the front end to suit your riding and conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension components are developed with a focus on consistent damping control and ride feel. This cartridge kit replaces internal fork components to deliver a more refined and communicative front end.

Who this kit is for

  • Yamaha R3 riders chasing better front-end feel and confidence
  • Road riders who want improved control without losing ride quality
  • Riders doing occasional track days who need repeatable adjustment

Shock design & features

  • NIX 22 fork cartridge kit for Yamaha R3
  • Improves braking stability and mid-corner control through refined damping
  • Premium internal components aimed at consistent performance and durability

Tuning controls

  • Separate compression and rebound adjustment for more precise setup changes
  • Designed to make tuning straightforward for road and occasional track use

Before you install

  • Professional installation is recommended to ensure correct assembly and setup
  • Set the adjusters to a sensible starting point, then tune one change at a time
  • After installation, recheck settings after your first rides to confirm balance

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU 21944-01
Model # NIX 22
Barcode # 2194401
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 22
Stroke Metal to Metal (mm) 120.0
Product Family NIX 22
Notes Spring series 08428-xx *Racing use only*
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01309-

More From This Category