The Ohlins FGK234 NIX 30 fork cartridge kit is built to improve front-end control and feel on the Yamaha YZF R1M. It focuses on delivering more precise damping behaviour for better composure during braking and through the middle of a corner. The result is a clearer, more communicative front end for fast road riding and track use.

Ohlins | Made to race, perfected to ride

  • Ohlins NIX 30 fork cartridge kit for Yamaha YZF R1M
  • Designed to enhance stability, feedback and damping consistency
  • High-quality internal components for durability under demanding use

Who this cartridge kit is for

  • Riders wanting improved front-end feedback and confidence at speed
  • Road riders who also do occasional track days
  • Anyone looking to refine braking stability and mid-corner control

Shock design & features

  • NIX 30 cartridge design aimed at delivering composed, communicative damping behaviour
  • Refined damping system intended to stay consistent over a wide range of conditions
  • Premium internal components to support reliability over time

Tuning controls

  • Separate compression and rebound adjustment to tailor feel and support
  • Adjustability suited to both street setup changes and track-focused tuning

Before you install

  • Professional installation is recommended to ensure correct fitment and setup
  • Plan time to set sag and dial in damping to suit your riding and tyres

Need help choosing?

If you want guidance on setup goals for road versus track, or you’re matching the front to an existing rear suspension package, our team can help you choose a baseline and tuning direction.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGK234
Model # NIX 30
Barcode # FGK234
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 30
Fork Length (mm) 749.0
Stroke Metal to Metal (mm) 120.0
Product Family NIX 30
Notes For FL 912 Race use only, 08790-xx series springs
Fitted Spring Sold separately. See notes.

More From This Category