The Ohlins FKR109 fork cartridge kit is designed to refine front-end control and consistency on selected Honda CBR1000RR SP and SP2 models. It focuses on improving feel under braking and through the middle of the corner, with damping behaviour intended to stay composed as conditions change. Adjustment is provided to help tailor the setup for your riding priorities.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension engineering, this cartridge kit is aimed at riders looking for clearer feedback and more predictable fork behaviour. It suits bikes originally fitted with Ohlins forks on the listed models.

Who this cartridge kit is for

  • Riders wanting a more controlled and communicative front end
  • Owners tuning for spirited road riding and occasional track use
  • Those chasing improved stability during braking and corner entry

Shock design & features

  • Fork cartridge kit format intended to improve damping precision and consistency
  • Internal components selected for stable performance and repeatable feel
  • Application noted for Honda CBR1000RR SP (Ohlins FL 910) and CBR1000RR SP/SP2 (Ohlins FL 926)

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Is it right for you?

If you want greater confidence from the front tyre, especially when braking hard and holding a line mid-corner, this kit is a logical step. If you are primarily commuting and not looking to tune suspension settings, you may not benefit from the available adjustability.

Before you install

  • Confirm your motorcycle model matches the applications listed above
  • Plan time for setup and test rides after installation to dial in rebound and compression

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKR109
Model # TTX25S
Barcode # FKR109
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Type Code TTX25S
Stroke Metal to Metal (mm) 120.0
Product Family FKR 100
Notes Comes with 3 different spring rates: 9.5 ,10 & 10.5N/mm. *Replaces FGR 178*
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01309-

More From This Category