The Ohlins FKR131 FKR 100 fork cartridge kit is a front-end upgrade for the Honda CBR1000RR-R SP, based on the Ohlins FL 971 application. It is designed to improve composure and communication from the front fork under braking and through cornering. Damping is externally adjustable to help you tailor feel and support to your riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins cartridge kits replace the internal damping components of the original fork to deliver more consistent control and clearer feedback. This kit is intended for riders who want a more stable front end and more usable adjustment than standard internals.

Who this cartridge kit is for

  • Honda CBR1000RR-R SP riders looking for improved braking stability and mid-corner feel
  • Riders who want front-end feedback that is easier to tune for road and occasional track use
  • Owners seeking a premium internal upgrade while retaining the existing fork outer tubes

Shock design & features

  • FKR 100 fork cartridge design for front fitment
  • Premium internal components aimed at consistent performance and durability
  • Separate damping circuits to support more controlled setup changes

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Before you install

  • Designed for Honda CBR1000RR-R SP fitment (Ohlins FL 971 application)
  • Confirm correct part number and fork compatibility before installation
  • Professional installation is recommended to ensure correct assembly and setup

Serviceability/lifecycle

As a cartridge kit with premium internals, the FKR131 is intended to be serviceable to maintain performance over time. Regular servicing helps keep damping consistent and protects internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKR131
Model # TTX25S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate Standard 10.0 N/mm
Type Code TTX25S
Fork Length (mm) 730.5
Stroke Metal to Metal (mm) 40.0 /4 N/
Product Family FKR 100
Fitted Spring 04744-10
Rec. Ohlins Oil 01309-

More From This Category