The Ohlins STX 36 twin rear shock set for Harley-Davidson touring models is built to deliver controlled damping and consistent feedback on the road. Designed as a matched pair for rear twin-shock fitments, it targets improved stability and composure across changing loads and surfaces. This unit uses a gas-pressurised damping layout to help maintain performance during sustained riding.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, predictability and service life. The STX platform is aimed at riders who want a clear connection to the chassis without making the bike harsh or nervous. For Harley touring applications, the emphasis is on stability, support and confidence.

Who this shock is for

  • Harley-Davidson touring riders wanting a more controlled rear end over varied road surfaces
  • Owners who carry a passenger or luggage and want consistent support from the rear suspension
  • Riders who prefer a twin-shock setup with a matched, serviceable damper package

Shock design & features

  • STX 36 twin-shock design for rear twin applications
  • Gas-pressurised damping system to support consistent damping behaviour
  • Matched pair supplied for left/right rear fitment

Tuning controls

This rear shock set provides external damping adjustment for both compression and rebound, allowing you to tailor support and recovery to your riding style and load. Independent circuits help you make changes with clearer direction when chasing comfort, stability or control.

Before you install

  • Confirm fitment for your Harley-Davidson model before installation
  • Set your initial adjusters from the factory baseline, then fine-tune after a short test ride
  • Re-check settings after any significant change in load (passenger/luggage)

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD039
Model # S36E
Barcode # HD039
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 311.0
Spring Rate Standard 26.0 N/mm
Type Code S36E
Stroke Metal to Metal (mm) 79.0
Product Family STX 36 Twin
Fitted Spring 66420-026
Spring Colour Black

More From This Category