The Ohlins TTX 30 rear shock is built for KTM 50 SX riders chasing predictable feel and consistent damping in motocross conditions. It uses a gas-pressurised design to help maintain damping control as temperatures and loads change through a moto. This unit is supplied without a spring, allowing you to match spring rate to rider weight and track demands.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing suspension know-how, the TTX 30 platform focuses on control and feedback rather than harshness. The result is a rear end that stays composed through braking bumps and supports cleaner drive out of corners.

Shock design & features

  • Gas-pressurised damping architecture for stable, consistent performance.
  • TTX 30 design intended to deliver clear chassis feedback and controlled wheel movement.
  • Rear shock unit for KTM 50 SX fitment.

Tuning controls

This rear shock includes external compression and rebound damping adjustments, so you can tune support and traction to suit track conditions, rider style, and tyre choice.

Before you install

  • No spring is supplied; the correct spring is selected separately (refer to the stated spring series note).
  • Use the recommended Ohlins suspension oil as specified for the product family.
  • After installation, set sag and damping from a sensible baseline before making single-change adjustments.

Serviceability/lifecycle

Like any performance shock, regular servicing helps maintain damping consistency and seal life. Service intervals depend on hours, conditions, and washing practices, so plan maintenance as part of your race/ride routine.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KT1397
Model # T30PR1C1W
Barcode # KT1397
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Shock Length Eye to Eye (mm) 276.0
Spring Rate No Spring/s Supplied
Type Code T30PR1C1W
Stroke Metal to Metal (mm) 72.0
Product Family TTX 30
Notes 00281- series spring
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category