The Ohlins HA1684 TTX 44 rear shock is built for Husqvarna FE and TE enduro models where consistent damping and clear chassis feedback matter. Using Ohlins’ TTX architecture, it’s designed to hold composure through changing terrain and sustained hard use. Supplied without a spring, it’s intended to be paired with the correct spring to suit rider weight and application.

Ohlins | Made to race, perfected to ride

TTX technology is developed from competition suspension and refined for real-world rideability. The focus is controlled damping behaviour, predictable traction and a stable feel across a wide range of speeds and impacts.

Shock design & features

  • TTX 44 rear mono shock design
  • Oil/gas separated construction for stable damping performance
  • Designed to suit Husqvarna FE 250/350/450/501 and TE 125/250/300 fitment as listed

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Preload adjustment (via spring preload once a spring is fitted)

Before you install

  • No spring supplied; spring is sold separately (see the product notes for spring series guidance)
  • Confirm correct spring rate for rider weight, luggage and typical terrain before setting sag

Serviceability/lifecycle

This unit is designed to be serviced and revalved as required, supporting long-term ownership and setup changes. Regular servicing helps maintain damping consistency and seal life, particularly in dusty or wet enduro conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HA1684
Model # T44PR1C2W
Barcode # HA1684
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 490.0
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Product Family TTX 44
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

More From This Category