The Ohlins TTX 30 rear shock for KTM 65 SX is built around consistent damping control for motocross use. It uses a pressurised design to help maintain stable performance as conditions change through a moto. Adjustment is provided to let you tailor chassis attitude and traction to your track and riding style.

Ohlins | Made to race, perfected to ride

Developed from Ohlins off-road racing experience, this unit is intended to deliver controlled wheel movement and clear feedback through changing loads. The aim is predictable behaviour under braking, through turns, and on acceleration.

Shock design & features

This is a gas-pressurised shock absorber with separated oil/gas to support damping consistency. The internal architecture uses dedicated damping circuits to manage wheel control across a wide range of impacts and chassis movements.

Tuning controls

External adjustment is provided for compression and rebound damping. These adjusters allow you to balance comfort versus support, manage traction on corner exit, and control how quickly the shock returns after an impact.

Before you install

  • No spring is supplied; a compatible spring must be selected and fitted separately.
  • Confirm fitment for your KTM 65 SX and set sag and damping from a sensible baseline before fine tuning.
  • Use the recommended Ohlins shock oil as specified by Ohlins for this model when servicing.

Serviceability/lifecycle

This shock is designed to be serviced and revalved as required. Regular oil and seal maintenance helps keep damping consistent and reduces wear over time, especially in dusty or high-hour motocross use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KT1698
Model # T30PR1C1W
Barcode # KT1698
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Shock Length Eye to Eye (mm) 348.0
Spring Rate No Spring/s Supplied
Type Code T30PR1C1W
Product Family TTX 30
Notes 00181- series springs *Replaced by DMX 0001*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category