The Ohlins SH1684 is a TTX 44 rear shock for Sherco SE-R and SEF-R models, built around Ohlins’ twin-tube damping concept for consistent control in demanding off-road conditions. It’s designed to deliver stable damping behaviour across varied terrain and pace changes. This unit is supplied without a spring, allowing spring selection to be matched to rider weight and use.

Ohlins | Made to race, perfected to ride

Developed from Ohlins’ competition suspension programs, the TTX platform focuses on controlled damping response and predictable chassis behaviour. The SH1684 is intended for enduro and off-road riders who want a more composed rear end and clearer feedback.

Who this shock is for

Suited to Sherco riders who ride technical trails, faster open sections, or race conditions where traction and stability matter. It’s a sensible option if you want improved consistency during longer rides and more confidence when the terrain gets rough.

Shock design & features

This is an oil/gas separated, gas-pressurised shock design intended to reduce cavitation and maintain damping consistency. The TTX 44 architecture uses separate damping circuits to help keep behaviour predictable when the shock is working hard.

Tuning controls

Adjustment is provided for rebound damping and compression damping, letting you tune how the rear recovers after impacts and how it resists loads under acceleration, braking and square-edge hits. These adjustments are designed to help you balance grip, comfort and chassis stability for your terrain.

Before you install

  • Spring is not supplied; select and fit the correct spring for your rider weight and intended use.
  • Confirm compatibility with your exact Sherco model and year before installation.
  • Set sag correctly and make damping changes methodically, one circuit at a time.

Serviceability/lifecycle

Like all high-performance off-road shocks, regular servicing helps maintain damping quality and seal life, particularly in muddy, dusty, or high-hour use. A planned service interval based on riding conditions will keep performance consistent.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SH1684
Model # T44PR1C2W
Barcode # SH1684
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Product Family TTX 44
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category