The Ohlins CC607 STX 36 Twin shock is a rear suspension unit developed for vintage and classic motocross applications. It is built to deliver controlled damping feel and consistent behaviour across changing track conditions. This model uses a gas-pressurised damping layout to support stable performance when the shock is working hard.

Ohlins | Made to race, perfected to ride

STX twin shocks carry Ohlins race-derived damping design in a format suited to twin-shock chassis. The aim is predictable control, traction and confidence without making the bike feel harsh.

Who this shock is for

Designed for riders restoring, racing or regularly riding vintage/classic motocross machines that run twin rear shocks. It suits those chasing clear feedback, improved rear tyre drive and stability through braking bumps and corner exits.

Shock design & features

This is an oil/gas (gas-pressurised) shock design rather than a basic emulsion-only layout. The damping is built around the STX 36 Twin architecture, intended to maintain consistency and resist fade during demanding motos.

Tuning controls

Independent compression and rebound damping circuits allow you to tune support and control to match rider preference and track conditions. This makes it easier to balance comfort, traction and chassis stability as grip and bump severity change.

Before you install

  • Confirm eye-to-eye length and stroke match your motorcycle’s requirements before fitment.
  • Check spring fitment and condition, and ensure correct mounting hardware is used.
  • After installation, re-check fasteners and alignment once the suspension has been cycled through full travel.

Serviceability/lifecycle

Like all high-performance shocks, periodic servicing helps maintain damping consistency and seal life. Fresh oil and inspection of wear components are especially important when the bike is used in dusty, high-impact motocross conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU CC607
Model # S36D
Barcode # CC607
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Shock Length Eye to Eye (mm) 340.0
Spring Rate Standard 12.0 - 14.3 N/mm Progressive
Type Code S36D
Stroke Metal to Metal (mm) 105.0
Product Family STX 36 Twin
Fitted Spring 00180-90
Spring Colour Black

More From This Category