The Ohlins KA2194 TTX Flow DV rear shock is built for Kawasaki KX 450F fitment where accurate damping control and consistent feel matter. Based on Ohlins race-developed architecture, it is designed to maintain predictable suspension behaviour through hard use. This unit is supplied without a spring, with spring selection handled separately to suit the rider and application.

Ohlins | Made to race, perfected to ride

Ohlins off-road shocks are developed from competition programs with a focus on control, traction and repeatable setup changes. The TTX Flow DV platform is intended to provide stable damping performance over a wide range of riding conditions.

Shock design & features

  • Gas-pressurised, oil/gas separated design to help maintain consistency under heat and repeated impacts
  • TTX Flow DV architecture aimed at precise damping control and strong chassis feedback
  • Application-specific shock body length for Kawasaki KX 450F fitment

Tuning controls

This rear shock provides external adjustment for compression and rebound damping, allowing you to tune response for track conditions, rider preference and tyre behaviour.

Before you install

  • Spring is not supplied; confirm the correct spring series and rate for your weight and riding type before installation
  • Check clearance, linkage condition and bearings as part of the install to ensure the shock can move freely through the stroke
  • Use the recommended Ohlins shock oil grade specified for this unit during service work

Serviceability/lifecycle

Like all performance off-road dampers, regular servicing helps keep damping consistent and protects internal components. Plan inspections and oil changes based on hours, conditions and how hard the bike is ridden.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA2194
Model # T46PR1C2W
Barcode # KA2194
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 485.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Product Family TTX Flow DV
Notes 06310 and 06451- spring series *replaced by DMX 0208*
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01304-

More From This Category