The Ohlins TTX Flow rear shock for the Suzuki RM-Z 450 is built for riders who want consistent damping control and clear chassis feedback across changing track conditions. The TTX architecture is designed to maintain stability under load while keeping traction predictable as the pace rises. Supplied without a spring, it’s intended to be matched to the rider and application.

Ohlins | Made to race, perfected to ride

Developed from competition-focused suspension know-how, this unit is aimed at repeatable performance rather than a “one setting fits all” feel. The TTX Flow layout prioritises control and consistency during long motos and rough-track impacts.

Who this shock is for

Suited to RM-Z 450 riders chasing a more controlled rear end, especially when pushing hard into braking zones and driving out of corners. It’s also a solid option when you want a shock that can be tuned methodically for track, tyre, and rider preference.

Shock design & features

This is a gas-pressurised, oil/gas separated rear shock using the Ohlins TTX Flow design. The intent is stable damping behaviour with good response to sharp hits, helping the bike stay composed while maintaining rear-wheel grip.

Tuning controls

External adjusters provide compression and rebound damping adjustment, allowing you to fine-tune support, comfort, and traction balance. This makes it practical to adapt the bike’s feel as track conditions evolve.

Before you install

  • No spring is supplied; select a suitable spring separately (see included notes for spring series guidance).
  • Use the recommended Ohlins suspension oil as specified for this unit.
  • After installation, set sag and baseline damping to suit your weight, pace, and typical terrain.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU1894
Model # T46PR1C1W
Barcode # SU1894
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category