The Ohlins TR909 TTX RT rear shock is built for riders chasing consistent damping control and clear chassis feedback. Based on Ohlins TTX technology, it uses a separated oil/gas design to help maintain damping stability during hard use. This unit is intended as a direct-fit rear mono shock for the Triumph Speed Triple.

Ohlins | Made to race, perfected to ride

TTX RT sits in the Ohlins road and track-focused range, bringing race-derived damping architecture to a street-based platform. The emphasis is predictable grip, stability and tunability rather than comfort-first compliance.

Who this shock is for

  • Track day and spirited road riders who want more control over rear grip and chassis attitude
  • Riders looking to tune the bike for tyre choice, pace and conditions
  • Owners upgrading from a basic OE shock to a purpose-built performance unit

Shock design & features

This is a gas-pressurised, oil/gas separated shock using Ohlins TTX architecture to support consistent damping behaviour. The layout is designed to provide stable response through a wide operating range and to reduce fade during repeated, high-load use.

Tuning controls

The TR909 provides external damping adjustment for rebound and compression, allowing you to shape support, traction and recovery speed to suit your setup. Spring preload adjustment is also provided to set ride height and balance to rider load.

Before you install

  • Set sag and baseline adjusters after installation to match rider weight and intended use
  • Confirm clearance and correct fitment for your specific Triumph Speed Triple model/variant
  • Plan for periodic servicing to keep damping performance consistent over time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU TR909
Model # T36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 293.5
Spring Rate Standard 110.0 N/mm
Type Code T36PR1C1
Stroke Metal to Metal (mm) 62.0
Product Family TTX RT
Fitted Spring 21141-39

More From This Category