The Ohlins STX 36 rear shock for the Yamaha XT 500 (1982) is a purpose-built mono shock replacement designed for consistent damping and dependable chassis control. Built around Ohlins’ STX architecture, it focuses on predictable response across a wide range of riding conditions. This unit is supplied as a complete rear shock with spring fitted.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered to deliver repeatable damping behaviour and long-term serviceability. The STX platform is widely used for riders chasing improved feel and control without compromising durability.

Shock design & features

  • Rear mono shock configuration for Yamaha XT 500 (1982)
  • STX 36 design
  • Emulsion-type shock (oil and gas in the same chamber)
  • Supplied with spring fitted

Tuning controls

This shock includes rebound damping adjustment to fine-tune how quickly the shock extends after compression. Rebound control is key for improving stability and maintaining tyre contact over successive bumps.

Base setup (factory preset)

The shock is delivered with an Ohlins baseline setting intended to suit the model as supplied. Final setup should be matched to rider weight, load and typical terrain by adjusting spring preload and rebound to preference.

Before you install

  • Confirm fitment for Yamaha XT 500 1982 and inspect all mounting hardware and bearings/bushes for wear
  • Set sag and preload after installation, then fine-tune rebound on a familiar test loop
  • Plan periodic servicing to keep damping performance consistent over time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA505P1
Model # S36P
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 295.0 +5.5/-0.5
Spring Rate Standard 105.0 N/mm
Type Code S36P
Stroke Metal to Metal (mm) 62.5
Product Family TTX RT
Fitted Spring 01093-36

More From This Category