The Tractive X-CITE shock for the BMW R 1100 S is a pressurised, oil/gas-separated rear shock built around a sealed cartridge architecture for consistent damping. This version includes rebound adjustment, giving you a straightforward way to fine-tune how the bike settles and recovers over bumps and load changes. Designed as a complete replacement unit, it focuses on controlled, predictable response rather than complexity.
Design & features
- Closed, pressurised damper design with separated oil and gas to help maintain damping consistency during sustained use
- Sealed cartridge-based construction to support stable, repeatable valving performance
- Coil-sprung shock assembly
Tuning Controls
- Rebound damping adjustment to tailor return speed after compression events (road undulations, corner exits, and load changes)
Base Setup (factory preset)
The shock is supplied with a baseline internal damping setup intended to suit general road riding. Use the rebound adjuster to balance control and comfort for your tyre choice, riding pace, and typical load.
Before You Install
- Confirm the application and fitment for your exact BMW R 1100 S variant before installation
- Inspect mounting hardware and linkage/rose joints (if fitted) and replace worn parts to avoid premature wear or inconsistent feel
- After installation, re-check fastener torque and verify clearance through full suspension movement
Serviceability/Lifecycle
As a sealed, pressurised performance shock, periodic servicing helps keep damping response consistent over time. Service intervals depend on use conditions and mileage, especially if the bike sees wet weather, rough roads, or frequent high-load riding.
Teknik Motorsport Pty Ltd Warranty terms for TracTive products.
This TracTive product has been assembled with the utmost care and tested according to ISO9001:2015 Quality system. In the unlikely event that the product does not fulfill your expectations because of faulty materials or manufacturing errors, please contact us through your dealer.
Teknik Motorsport Pty Ltd warrants that if, within 24 months of the date of sale the product is found to be defective as a result of manufacturing errors or faulty components, the product will be repaired free of charge by us, or by a TracTive approved repairer at our discretion.
Warranty covers the direct service material cost, service labour cost ($80/hr AUD) and shipping costs of the service partner. Other costs will be regarded on a case by case basis by Teknik Motorsport and TracTive.
When a claim is made under the warranty, the following conditions have to be met:
- You must have read the instructions carefully before mounting the product in the vehicle or adjusting the product.
- The product has to be installed and adjusted as described in the instructions
- The product must have been maintained and serviced in accordance with the recommendations in the manual. If not described in the manual, the recommended service intervals for regular street use: every 30.000 km or max 2 years, whichever is earlier.
- Warranty shall apply only when TracTive original parts, procedures and tools have been used to service and/or repair, and if service and repair is performed by designated TracTive partners.
- The product may not have been neglected, improperly used, altered or subjected to excessive loads. Excluded from warranty are normal wear, damage and rust.
- A sales receipt or other proof of purchase originally eminating from Teknik Motorsport Pty Ltd. No warranty will be given on TracTive or Touratech products not purchased from or through Teknik Motorsport pty ltd.
- Excluded from warranty are in particular products which are used in vehicles that are intended or suitable for taking part in sporting events, or have actually been used this way.
- Recommended service interval for Motorsport applications: every season, or every 50 hours, every 10.000km or after any perceived loss in performance.
| SKU | 46BM00-R3121-TR |
| Model # | 46BM00-R3121-TR |
| Barcode # | 46BM00R3121TR |
| Brand | TracTive Suspension |
| Shipping Weight | 5.0000kg |
| Shipping Size | 0.200 x 0.200 x 0.400m |
| Unit Of Measure | ea |
| Type | X-CITE |
If your Motorcycle is listed below, this product will suit:
| Position (Front or Rear) | Front |
| Damping Adjustment Type | Rebound |
| Seat Height Change (mm) | Sport Chassis |
| Shock Length Eye to Eye (mm) | 330.0 |
| Spring Rate Standard | 60 N/mm |
| Type Code | X-CITE |
| Stroke Metal to Metal (mm) | 69.0 |
| Fitted Spring | 60-205 |






