The Ohlins FGR156 FGR 100 complete front fork is a full front-end fork assembly for the Kawasaki ZX-6R (600cc). It is designed to deliver clear front-tyre feedback and improved braking stability through controlled damping behaviour. With external adjustments for key damping circuits, it supports careful setup for road riding and track use.

Ohlins | Made to race, perfected to ride

Developed as part of the Ohlins FGR 100 family, this complete front fork focuses on consistent damping control and predictable feel at the lever and bars. The goal is a composed front end that stays communicative as conditions and pace change.

Who this fork is for

  • Kawasaki ZX-6R (600cc) riders wanting a more stable and confidence-inspiring front end
  • Riders who value improved braking stability and mid-corner feel
  • Owners looking for a complete front fork solution rather than an internal-only upgrade

Shock design & features

  • Complete front fork assembly (front mounting position)
  • Precise damping characteristics aimed at better control and consistency
  • Premium internal components selected for durability and repeatable performance

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment
  • Adjustability intended to simplify fine-tuning for road and track conditions

Before you install

  • Confirm compatibility with your exact Kawasaki ZX-6R (600cc) variant before fitting
  • Allow for correct setup of damping and springing to suit rider weight and usage
  • Kit includes fitted springs: Springs -90, -95, -10
  • Listed stroke: 120 mm

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGR156
Model # NIX 30
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate Standard 9.5 / 10.0 / 10.5 N/mm
Type Code NIX 30
Stroke Metal to Metal (mm) 120.0
Product Family FGR 100
Notes *Replaced by FKR 107*
Fitted Spring Springs -90 -95 -10 included in kit

More From This Category