The Ohlins STX 46 Adventure rear shock for the BMW R 1150 GS is built for consistent damping control when riding loaded, over mixed surfaces, and across long distances. It’s designed to improve chassis stability and maintain tyre contact when conditions and pace change. The STX architecture focuses on predictable behaviour and reliable adjustment rather than sharp, track-only response.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping consistency and serviceable construction. For adventure and touring use, that translates to a calmer bike over rough roads and better support when carrying luggage or a passenger.

Shock design & features

This is a monotube rear shock using a gas-separated design to help keep damping performance consistent during extended riding. The STX layout is intended for durability and stable oil control in real-world heat and vibration.

Tuning controls

Adjustment is provided for rebound damping and spring preload, allowing you to tailor the rear of the bike for load, terrain, and rider preference. Rebound adjustment helps control how quickly the shock extends after a bump, while preload is used to set ride height and support for different weights.

Base setup (factory preset)

The shock is supplied with an Ohlins-developed baseline intended to suit the standard application. From that starting point, fine-tuning is typically done to account for luggage, pillion use, and the balance you prefer between comfort and support.

Before you install

Confirm your model and fitment details before installation, and inspect bearings/bushings and mounting hardware condition. After fitment, set sag and then adjust rebound in small steps to match your load and typical riding surfaces.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to maintain performance over time. Routine servicing helps keep damping consistent, particularly for adventure riding where dirt ingress and long heat cycles are common.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM045
Model # S46DR1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 383.0
Spring Rate Standard 140.0 N/mm
Type Code S46DR1
Stroke Metal to Metal (mm) 63.0
Product Family STX 46 Adventure
Notes Rear
Fitted Spring 01095-54
Spring Colour Yellow

More From This Category