The Ohlins BM216 STX 46 Adventure front shock is built for the BMW R 1150 GS Adventure where control and consistency matter on mixed surfaces. It is designed to keep the front end settled through rough tracks and long-distance touring. The internal layout uses a single-tube gas-separated design to maintain damping stability.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing and endurance know-how, this unit is aimed at riders who want predictable front-end feel and confidence when conditions change. The focus is on controlled movement, traction and reduced rider fatigue over long days.

Who this shock is for

  • BMW R 1150 GS Adventure riders looking for a dedicated front shock for adventure and touring use
  • Riders who want improved composure on corrugations, rocky climbs and uneven surfaces
  • Owners carrying luggage or riding two-up who want stability without harshness

Shock design & features

  • STX 46 Adventure series front shock for the R 1150 GS Adventure
  • Monotube architecture with oil and gas separation for consistent damping
  • Built for durability in harsh conditions and regular off-road use

Tuning controls

This shock includes external rebound damping adjustment to fine-tune how quickly the front returns after a bump. This makes it easier to match the bike to load, terrain and rider preference without disassembly.

Before you install

  • Confirm fitment and mounting position: front mono for BMW R 1150 GS Adventure
  • Inspect linkage and mounting hardware for wear before fitting a new shock
  • After installation, set sag and then fine-tune rebound damping to suit your typical load and terrain

Serviceability/lifecycle

Like all performance dampers, periodic servicing helps maintain damping quality and seal life. Keeping it clean after dusty or wet rides and servicing on schedule will preserve consistent behaviour over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM216
Model # S46ER1
Barcode # BM216
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 344.5
Spring Rate Standard 52.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 101.5
Product Family STX 46 Adventure
Notes Front
Fitted Spring 01096-10
Spring Colour Yellow

More From This Category