The Ohlins BM340 TTX GP rear shock is a track-focused unit for the BMW S 1000 RR. Built around Ohlins’ TTX architecture, it’s aimed at delivering consistent damping behaviour and clear chassis feedback under hard use. This is a dedicated rear mono shock designed for riders who want dependable adjustability for circuit tuning.

Ohlins | Made to race, perfected to ride

BM340 is part of the Ohlins TTX GP family, developed from competition experience and intended for precise suspension control on track. It suits riders prioritising stability, traction and repeatable performance across a session.

Who this shock is for

  • BMW S 1000 RR riders setting up primarily for track days and racing
  • Riders who want a wider tuning window to suit tyres, pace and circuits
  • Those chasing clearer rear-end feel during braking, turn-in and corner exit

Shock design & features

This is a gas-pressurised design with oil and gas separation to help maintain damping consistency during sustained, high-load riding. The TTX layout is engineered to deliver predictable response through the stroke, supporting chassis balance under aggressive inputs.

Tuning controls

The BM340 provides external damping adjustments for both compression and rebound, allowing you to tune support under braking and acceleration separately from recovery control. This makes it well suited to systematic track setup changes as conditions, tyres and riding style evolve.

Before you install

  • Confirm application: listed for BMW S 1000 RR (note: not HP4).
  • Check clearance and linkage condition, and ensure bearings and fasteners are in good order before fitting.
  • After installation, set sag and baseline damping to suit your weight and intended track use.

Serviceability / lifecycle

As a rebuildable Ohlins unit, the BM340 is intended to be serviced to maintain performance over time. Regular inspection and oil service intervals should be based on track hours and operating conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM340
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 310.0 +5/-1
Spring Rate Standard 85.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 62.0
Product Family TTX GP
Notes TTX GP. Not HP4 Replaced by BM 361
Fitted Spring 21040-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category