The Ohlins BM342 TTX GP rear shock absorber is built for the BMW S 1000 RR and aimed at riders chasing consistent chassis control under hard use. Based on Ohlins’ TTX architecture, it is designed to deliver clear feedback and stable damping behaviour when loads and speeds change quickly. This is a gas-pressurised, oil/gas separated rear mono shock intended for precise tuning rather than set-and-forget riding.

Ohlins | Made to race, perfected to ride

TTX GP components are developed from competition experience and refined for performance-focused road and track riders. The goal is predictable damping, strong mechanical grip and a suspension feel that remains consistent across a session.

Who this shock is for

  • BMW S 1000 RR owners who want a track-capable rear shock with broad tuning range
  • Riders looking for improved stability under braking and drive on corner exit
  • Anyone who values repeatable adjustability and clear setup feedback

Shock design & features

  • Ohlins TTX GP rear mono shock design
  • Gas-pressurised, oil/gas separated layout for consistent damping behaviour
  • Separate damping circuits intended to keep control precise as conditions change

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Hydraulic preload adjustment

Before you install

  • Confirm fitment for your exact BMW S 1000 RR model and year before installation
  • Set sag and preload for your weight and intended use, then fine-tune damping from there
  • Have installation and setup carried out by a qualified technician if you’re unsure

Serviceability/lifecycle

As a serviceable Ohlins unit, this shock is designed to be maintained and revalved as requirements change. Regular servicing helps keep damping performance consistent and extends component life, especially with frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM342
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 314.0 +3/-3
Spring Rate Standard 85.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 62.0
Product Family TTX GP
Notes TTX GP
Fitted Spring 21040-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category