The Ohlins BM365 TTX GP rear shock is built for the BMW S 1000 R and developed from Ohlins race suspension architecture. It is designed to deliver consistent damping control and clear chassis feedback when riding hard on track or fast road. This unit uses a separated oil and gas design to help maintain stability and reduce fade over longer sessions.

Ohlins | Made to race, perfected to ride

TTX GP shocks are aimed at riders who want predictable grip and support under braking, turn-in and corner exit. The BM365 is a rear mono shock application intended for performance-focused setups where damping consistency and adjustability matter.

Who this shock is for

  • Track riders chasing repeatable feel across a session
  • Fast road riders wanting more control and feedback than a standard rear unit
  • Owners who plan to tune spring and damping to suit tyres, pace and conditions

Shock design & features

This is an Ohlins TTX GP rear shock with a separated oil/gas layout. The internal architecture is designed to keep damping behaviour stable as temperatures rise, and to improve rear tyre contact feel when loads change quickly.

Tuning controls

The BM365 provides external adjustment for rebound damping and compression damping. This gives you the ability to balance support and traction for your riding style, and to fine-tune the bike’s attitude through braking and acceleration phases.

Before you install

  • Confirm spring rate and sag are set for rider weight and intended use
  • After installation, re-check fasteners and clearances through full suspension travel
  • Plan periodic servicing to keep damping performance consistent over time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM365
Model # T36PR1C1LB
Barcode # BM365
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 335.0 +4/-2
Spring Rate Standard 75.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 62.0
Product Family TTX GP
Notes TTX GP
Fitted Spring 21040-21
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category