The Ohlins BM417 STX 46 Adventure rear shock is built for BMW GS models that see a mix of sealed roads and demanding unsealed tracks. It is designed to deliver consistent damping control over long distances and variable surfaces. This is a monotube shock with oil and gas separated to help maintain stable performance when the pace or conditions change.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing and endurance experience, the STX Adventure range focuses on predictable chassis behaviour and control in real-world adventure use. The BM417 is intended to suit the standard rear shock position on compatible BMW models.

Shock design & features

This unit uses a 46-series monotube architecture with separated oil and gas, helping reduce fade and maintain damping consistency on corrugations and repeated hits. The construction is aimed at durability for adventure touring loads and rough-surface use.

Tuning controls

External adjusters allow you to tailor the shock to conditions and load. This model provides rebound damping adjustment and spring preload adjustment, making it easier to set the bike up for solo riding, luggage, or a pillion.

Base setup (factory preset)

The shock is supplied with an Ohlins baseline setting as a starting point. Fine-tuning is typically done by setting sag via preload first, then adjusting rebound to control how quickly the rear returns after bumps and under acceleration.

Before you install

Confirm fitment for your exact BMW model and year, and inspect mounting hardware and bushes during installation. After fitting, re-check fasteners and set preload and rebound to suit your usual load and riding conditions.

Serviceability/lifecycle

As an Ohlins unit, the shock is designed to be serviceable. Periodic servicing helps maintain damping performance and reliability, particularly for bikes used in dusty, wet, or heavily loaded adventure touring.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM417
Model # S46ER1W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 335.0
Type Code S46ER1W
Stroke Metal to Metal (mm) 92.0
Product Family STX 46 Adventure

More From This Category