The Ohlins BM444 STX 36 Adventure Shock is a front shock absorber built for controlled, consistent damping on adventure and touring applications. It is designed to maintain stability and comfort when conditions change across sealed roads, gravel and rough surfaces. As an Ohlins unit, it is intended to be tuned to suit rider weight, load and riding pace.

Ohlins | Made to race, perfected to ride

Ohlins suspension units are engineered with a focus on damping control, thermal stability and long-term serviceability. This model sits within the STX 36 Adventure family and is intended for riders who want a more composed front end under varied terrain and loads.

Who this shock is for

  • Adventure and touring riders looking for improved front-end composure over uneven surfaces
  • Riders carrying luggage or a pillion who want more predictable support and stability
  • Owners who value adjustability to fine-tune feel for different routes and conditions

Shock design & features

This is an emulsion-type shock, where oil and gas are housed within the main body. The STX 36 Adventure architecture is aimed at delivering consistent damping and a controlled response across a wide range of riding conditions, with a build intended to tolerate harsh use and long days in the saddle.

Tuning controls

External adjustment is provided for rebound damping, allowing you to tune how quickly the suspension returns after a bump. This helps tailor traction, support and ride comfort depending on surface, load and riding style.

Before you install

  • Confirm fitment for the intended BMW application and mounting position (front)
  • Check sag and spring suitability for your typical rider/load use case
  • After installation, set rebound to a sensible baseline and fine-tune in small steps based on feel

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be serviced. Periodic maintenance helps keep damping consistent and extends component life, particularly when used regularly in dusty, wet, or heavily loaded adventure conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM444
Model # S36ER1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Shock
Shock Length Eye to Eye (mm) 296.0
Spring Rate Standard 62.0 N/mm
Type Code S36ER1
Stroke Metal to Metal (mm) 65.0
Product Family STX 36 Adventure
Fitted Spring 00180-65

More From This Category