The Ohlins TTX GP rear shock for BMW HP 4 and S 1000 RR is built around proven race-derived damping architecture for precise chassis control. It is intended for riders chasing consistent feedback and tuneability in demanding conditions. This unit is specified for rear mono-shock fitment and is supplied with a fitted spring.

Ohlins | Made to race, perfected to ride

From the Ohlins TTX GP family, this shock is focused on delivering clear feel and stability when pushing hard. The damping system uses separated oil and gas to help keep performance consistent as loads and temperatures rise.

Who this shock is for

  • Track-focused riders and racers who want a dedicated rear mono-shock with broad adjustment range
  • Owners of BMW HP 4 and S 1000 RR seeking a suspension solution designed for race use
  • Riders who value predictable grip and chassis behaviour over comfort-focused tuning

Shock design & features

  • TTX GP architecture with oil/gas separation for stable damping behaviour
  • Designed for rear mono-shock installation
  • Supplied with a fitted spring (yellow)

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Intended for race use; confirm suitability for your riding environment before fitment
  • Check clearance, linkage condition, and bearing health to get the best from the shock
  • Have sag and damping settings set by a competent suspension technician for your weight, tyres, and track surface

Serviceability/lifecycle

This Ohlins unit is fully serviceable and designed to be maintained as part of regular track or race preparation. Routine oil and seal service helps preserve damping consistency and component life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM468
Model # T36PR1C1LB
Barcode # BM468
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 353.0 +2/-4
Spring Rate Standard 85.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 58.0
Product Family TTX GP
Notes TTX GP Race use only
Fitted Spring 21040-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category