The Ohlins BM540 STX 36 Supersport rear shock is built to deliver controlled, repeatable damping for the BMW K 1200 LT. Developed from Ohlins racing experience, it focuses on traction, stability and clear feedback through the chassis. The gas-pressurised design is intended to maintain consistent performance as conditions change.

Ohlins | Made to race, perfected to ride

STX technology is designed to give predictable damping behaviour and strong support under load. This unit is configured as a rear mono shock for a direct fitment application.

Shock design & features

  • Gas-pressurised damping system to help reduce fade during extended use
  • STX architecture aimed at stable, consistent damping response
  • Designed for rear mounting on the BMW K 1200 LT

Tuning controls

This shock includes rebound and compression damping adjustment, allowing you to balance support, traction and ride feel to suit your load and road conditions.

Base setup (factory preset)

Supplied with an Ohlins-fitted spring and a baseline setting intended to suit the standard application. From there, adjustments can be used to refine comfort versus control depending on riding style and typical payload.

Before you install

  • Confirm model fitment and correct rear mounting orientation before installation
  • Check sag and overall ride height after fitting, especially if carrying regular passenger or luggage loads
  • Inspect linkage/bushings and hardware condition during installation

Serviceability/lifecycle

Like all performance dampers, periodic servicing helps maintain damping consistency and seal life. Regular inspection for leaks or changes in damping feel is recommended, particularly if the bike is used frequently or heavily loaded.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM540
Model # S36D
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 319.0
Spring Rate Standard 85.0 N/mm
Type Code S36D
Stroke Metal to Metal (mm) 82.0
Product Family STX 36 Supersport
Notes Front
Fitted Spring 00180-56
Spring Colour Yellow

More From This Category