The Ohlins BM548 STX 46 Adventure rear shock is designed for riders chasing consistent control and comfort on a BMW K 1200 LT. Built for real-world touring conditions, it aims to keep the bike composed when road surfaces deteriorate and loads change. The focus is predictable damping, stability and support over long distances.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a strong engineering focus on damping control and ride feel. This unit is built to suit the chassis requirements of the BMW K 1200 LT in rear mono-shock form.

Who this shock is for

  • BMW K 1200 LT riders wanting a controlled, comfortable rear end for long-distance touring
  • Riders who regularly carry luggage and want stability as load varies
  • Anyone seeking a quality replacement rear shock with adjustability for setup

Shock design & features

This is an STX 46 Adventure rear mono shock with a separated oil/gas design for consistent damping. The construction is intended to manage heat and maintain control across long rides and changing conditions.

Tuning controls

The shock includes rebound damping adjustment and compression damping adjustment, along with a spring preload adjuster to suit rider load and ride height preferences. These adjustments allow you to fine-tune comfort, support and stability without changing components.

Before you install

  • Confirm fitment for BMW K 1200 LT and rear mono mounting position before installation
  • Inspect linkage and mounting hardware condition, and service/replace worn bearings as required
  • Set sag and then refine preload, rebound and compression to suit your typical load (solo, luggage, pillion)

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain damping consistency and seal life. If ride quality changes over time or adjustment response becomes inconsistent, a service is recommended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM548
Model # S46DR1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 400.0
Spring Rate Standard 200.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 55.0
Product Family STX 46 Adventure
Fitted Spring 01099-84

More From This Category